Skip to main content
Call Eric:863-698-8266
CURRYCONTROLS.COMControls & Automation Knowledge Hub

Water & Wastewater › Water Systems

Water Pumping

Moving potable water from the source to the tap.

6 topics6 written guides

Written guides in this section

Full references, procedures, and diagnostic guides published under Water Pumping.

ReferenceWaterPumps

Well Pump Control

Controlling a groundwater well: submersible and line-shaft turbine pumps, the pump-to-waste start, drawdown and the low-water cutoff, cycling limits from the well and the aquifer, and what the controller monitors to protect a pump that cannot be seen.

10 min readUpdated Sep 5, 2026

ReferencePumpsWater

High Service Pumps

The pumps that carry finished water into distribution: types, the pump curve against the system curve, best efficiency point, the affinity laws and where a drive pays, parallel operation, valves, protection, and the efficiency monitoring that shows wear.

11 min readUpdated Sep 5, 2026

ReferenceWaterPumps

Booster Pump Stations

Inline stations that raise pressure from one zone to another: suction pressure protection, discharge pressure control with drives, staging, the hydropneumatic tank alternative, surge and check valve behavior, and the interlocks that keep a booster from collapsing the zone it draws from.

9 min readUpdated Sep 5, 2026

ReferenceWaterPumps

VFD Control for Water Pumping

Variable speed pumping and where it earns its cost: the affinity laws and how static head limits the savings, the minimum speed a pump can run, pressure, flow, and level control with a drive, and how to estimate the savings before buying.

9 min readUpdated Sep 5, 2026

ReferenceWaterPumps

Distribution Pressure Control

How a booster or high service pump station holds discharge pressure with variable speed pumps, how pumps are staged, and what stops the system hunting.

9 min readUpdated Sep 5, 2026

ReferenceWaterPumps

Flow Control in Water Pumping

Controlling the flow a pumping system delivers: speed against valves, flow-paced pumping to a treatment rate, the flow loop with its ramp limits and its meter placement, and the loop tuning that keeps a flow controller steady.

8 min readUpdated Sep 5, 2026

Topics in this area

Direct contact

Have a controls question?

Reach Eric Sullivan directly about anything on this site, a controls or automation topic, or one of his personal projects.

References to manufacturers, products, model numbers, software platforms, technical specifications, companies, standards organizations, or other organizations are provided for informational purposes and do not imply sponsorship, endorsement, authorization, or affiliation unless expressly stated. Manufacturer specifications must be independently verified against current manufacturer documentation.